Tips to change your Oil Car Engine

Tips to change your Oil Car Engine


Although actually an oil change your car engine is a simple process, many people prefer to go to the garage to replace it. Here are some tips for those who like a bit of time and cost savings by changing the oil in the engine itself.


Preparation Steps :

1. Place your car at the surface is really flat.

2. Cars must be really in a condition to stop (not moving). If necessary, use Jack is the car body to hold.

3. Jack stands should always be installed when the car was appointed to the jack. Do not be under the car if the car is still in a state of jacked.

4. Always use thick gloves and anti-heat, while changing the engine oil, hot oil valve cover to avoid.

Equipment needed :

1. Guide. It is very important to be able to provide information about the nature of the engine oil to find and how much needed dose of your car engine

2. Car engine oil

3. Used oil collector bowl

4. New oil filter

5. Key oil filter

6. Tooth lock opener

7. Gloves

8. A set of bolt lock

9. Rag

10. Funnel

11. Two jack stands or car body buffer

12. Jack

Oil changing :

1. When we prepared the equipment for an oil change the car, let the engine burns about 10 seconds before you start changing the oil. Then place the car on a flat surface and put a hand or hand brake brake.

2. Place the connector on top of a hard surface and a state of maintaining the car body.

3. Dongkraklah the front of the car with caution. If necessary, enter the first gear the car manual to send. Or, more convincingly, ganjallah rear tires with rocks.

4. Look at the manual, where the location of the valve to remove oil. It is normally on the front-middle-bottom of the car.

5. Make sure the containers used oil container under oil dump valve before opening the valve. By using the key opener, the valve opens clockwise (if you open the top). Be careful, it could be the temperature of the oil is hot.

6. Let the oil until it comes out completely discharged, while the clean oil discharge valve and open the valve of the new oil policy. After it was placed back exhaust, reinforced with a reasonable (not too tight).

7. Replace the old oil filter with a new one. Check the seal of the filter and add a new layer of thick layer of film to the seal. Then install a new oil filter and turn it by hand.

8. After the new filter is installed, the engine oil cap, insert the funnel and put the new engine oil, in accordance with a direction to the guide attached. After dosing with, near the oil cap back on and clean up oil around the hole.

9. Turn on the car and let the engine run for a while. Then check the height of the oil with the measuring stick (which is already on the machine terpasan) to add more oil if needed.

10. Investigate the possibility of leaks in drains oil and new oil filter. If there is increased until no visible oil delivered. Again, if you add the oil with the right dose to get there is a leak in the engine oil. Then you immediately to the location of leaks. Or immediately contact the nearest service station.

Note the date of the replacement of the oil and mileage of your car. Oil should be changed every 3000 km, or once every three months if you do not often and not much driving. A late replacement for oil will lead to easier and the engine temperature increases through the rough engine sound.

When changing the oil, you should also check other engine parts also contain liquids, such as cooling, power steering, transmission and brakes. Who knew required the addition of brake fluid or oil, so you can also control. Well, good luck.